BLASER SCOPE RING

Excellent quality Blaser rings for your Blaser scope mount.

• Select two rings for a pair.
• Each ring comes with a replacement hex head attachment screw.
• The Blaser mount will typically fit all scopes with tubes and objective lens up to 58mm, with options to fit even larger scopes.
• Be sure to check that your scope will fit between the rings and that the scope bridge will clear the top of the saddle mount base. Table of dimensions are provided on the product picture.
• Every Blaser scope mount has 12moa elevation built into the saddle base. This makes them a great choice for pairing with scopes with dial up turrets for medium and long range shooting.
• This rings are the newer style - see info below to identify if any existing rings you may have will fit this scope mount base.

New style mount and rings

The newer style scope mount has recessed slots in the base to accept the new style rings.
The new style rings halves screws are located at the bottom of the ring and screw in at an angle. These rings have a flat bottom to fit into the recessed slot in the new style base.

Old style mount and rings

The old style rings sit proud and on top of mount, not into a recessed in a slot.
The rings halves screws are located halfway up the ring and screw in vertically. This ring has a proud tail to screw into the old style base.

• Old and new rings are not interchangeable between the two style mounts bases. 
• The old style rings do not fit in the new style scope mount base above.
• The new style rings above do not fit into the old style scope mount base below.
• The old style scope mount bases are discontinued.